Cookie Consent by Free Privacy Policy website Skip to content

Pin load cell

Custom Gicam pin load cells: load pins designed to the customer's drawing for cranes, cableways, rope tension, dynamometric beams and machinery.

A pin load cell (load pin) replaces an existing pin in the structure, such as a pulley axle or an arm joint, and measures the force passing through it without modifying the system.

Almost all the load pins we produce are custom made: dimensions, cable exit and capacity depend on the machine they are fitted to. We design them to the customer's specifications or drawing, even as single pieces or small batches.

On request we manufacture ATEX and/or IECEx certified load pins for potentially explosive atmospheres and load pins for offshore applications and marine environments.

How a load pin works

Inside the pin, at the shear sections between the support shoulders and the point where the load is applied, strain gauges are bonded and wired in a Wheatstone bridge. When the pin is loaded, the deformation of these sections produces an electrical signal proportional to the force, which is read by an indicator or transmitter and passed to the PLC, a display or a load limiter.

Applications

  • Rope tension: measuring rope tension on deflection pulleys and sheaves.
  • Cableways and rope systems: continuous monitoring of loads on sheaves and anchor points.
  • Cranes, hoists and overhead cranes: measuring the lifted load and load limiting, with the pin fitted in the sheave or hook attachment.
  • Dynamometric beams: load pins built into the beam for lifting operations and load tests.
  • Offshore and marine: load pins for deck cranes, winches and mooring and lifting systems in marine environments.
  • Machinery and structures: cylinder and arm joints, tie-rod attachments, presses and automation lines, wherever the force passes through a pin.

Load pins to your design or drawing

To design the pin or prepare a quote we need:

  • the drawing of the housing or of the current pin, with diameter, length and position of the shoulders;
  • the load direction and its maximum value, including any overloads or dynamic loads;
  • the environmental conditions: outdoor use, humidity, temperature, ATEX zone or offshore environment;
  • the cable or connector exit and the required signal.

If you have no drawing, we can start from the housing dimensions and a description of the application: our technical department will propose a solution.

Standard version features

The catalogue model PE is made of stainless steel, with capacities from 1 to 100 t, 1 mV/V output and IP67 protection, and is available on request with ATEX or IECEx certification. Custom versions keep the same basic features, adapted to the application.

Mounting of load pins

When mounting the pin in the housing shoulders, pay careful attention to the cable and the cable gland and do not use a hammer or other tools to force the pin in. The pin must be oriented according to the marked measuring direction and secured against rotation and axial movement with the retaining plate: a pin rotated away from the load direction reads less than the actual load.