The toroidal hydraulic load cell TOR-IDRA/M measures changes in workload on rods and anchors subjected to tension, allowing in this way to evaluate carefully the possible losses for release during exercise or pressure increases, due to thrust on the ground containment structures.
BA-EST/CV fingers vibrating wire strain gauge are used to measure the stress states existing structures or to monitor tensions existing in the ribs, during the excavation of the tunnels. Such control is necessary for the verification of the stress and supporting structures strain both temporary and permanent.
The load limiters "M/G FX" series are extremely small and easy to handle, with aluminum load cell body with high protection degree (IP 67) for application in any environment. "M/G FX" applied to the fixed head rope and the simple installation procedure takes only a few minutes.
The new GD4VIS and ME1VIS compression load cells have the ability to view directly on the load cell the value of the applied load. Through a built-in indicator load cell is capable to display applied load, set filters, set the peak and linearize load points.
Steel frame powder coated (optional) stainless steel.
Fixing elements in AISI 316 stainless steel
Load Cell Pin to Pin & 17.4PH steel and stainless steel
Pulleys hardened steel (standard) or stainless steel 17.4 PH (optional)
Self-lubricating ball bearings, working temperature from -20 ° Work to +70 ° C.
Output Signal:
